In Mac systems, the model determines the amount of RAM that the system can handle. Therefore, if the model does not support it, you cannot install it on your PC. The acceptable RAM for some of the popular models are:. Your operating system might support a lot of RAM space, but if your hardware does not allow it, purchasing more would be a waste. To know the space supported by your hardware, you need to use either of these options:. After going through the actions of finding out if your laptop is upgradeable and the extent you can upgrade it too, the next step is to install the new RAM.
First, you need to get the right RAM and the necessary tools. Then, you can start the upgrade purpose. You need to be equipped with the right tools to ensure the installation of a new RAM goes smoothly.
We recommend the following:. Step 4: After removing your battery, you will notice that there are certain screws around the panel. Get your screwdriver that has the same end as the screws. Step 7: Next area you will see is the RAM.
Carefully remove it using your fingers. Step 8: If the RAM is tightly stuck within the enclosure, you can use the flat screwdriver to carefully pry it out. Step 9: Replace the old RAM with the newly purchased one by finding the correct orientation.
Step Wait for at least 5 minutes to ensure your system reorientates itself with the new RAM. Then, click Find my computer. Step 3: This tool will tell you the maximum memory and how many slots your laptop has. If there is only one slot and the maximum memory is larger than your RAM, you can replace the memory with a large one for the upgrade. After knowing if you can add RAM to your laptop, now you need to purchase a proper memory module based on your actual situation.
Step 2: Open the panel of your laptop that covers the memory banks on the bottom. Sometimes, you need to unscrew the whole back of the machine to access the memory. Step 4: If there is only one memory slot, you should remove the existing memory module to replace it.
Just push apart the clips that hold it in place and it should pop up at an angle. Then, lift the module out by holding its edges. First, turn off your laptop and unplug the power adapter. Next, open the panel on the bottom of your laptop covering the memory banks. Depending on your system, you might have to unscrew the whole back of the laptop to access the memory and other components. Before you touch any component in your PC, though, touch any metal surface inside the computer e.
This will discharge any potentially damaging static electricity from your body. If all of your memory slots are already filled, you'll need to pull out the existing DIMMs in order to replace them. To remove the memory module, push apart the clips holding it in place. The memory module should pop up at an angle. Then, holding the memory module by its edges — without touching the gold connectors at the bottom, lift the module out.
Next, insert the new modules into your open slots at a degree angle, with the gold edges facing down. Use even pressure with your fingers at the top of the modules to push them into place. When you hear a click and feel a DIMM snap into place, firmly push the module back until it is installed flat and level, with the clips holding it securely.
0コメント